Skip the navigation

How do you assemble and adjust the tilt-head mixer?

When you first unpack your KitchenAid tilt-head mixer, it's time to set it up. Find out how to assemble and adjust it ready to create. See the steps...

Your stand mixer is designed to be straightforward to use, so you will quickly become familiar with it and enjoy getting creative. Here are the instructions for setting it up.

How to secure the bowl:

  1. Turn OFF (speed '0')
  2. Unplug the mixer or disconnect power. how do you secure the bowl assembling tilt-head mixer step 1
  3. Tilt the motor head back.
    how do you secure the bowl assembling tilt-head mixer step 3
  4. Place bowl on silver metal bowl clamping plate. how do you secure the bowl assembling tilt-head mixer step 4
  5. Turn the bowl gently in a clockwise direction, making sure handle or spout of glass bowls does not touch the back of the mixer base. how do you secure the bowl assembling tilt-head mixer step 5

How to remove the bowl:

  1. Turn OFF (speed '0')
  2. Unplug the mixer or disconnect power.
  3. Tilt motor head back.
  4. Turn bowl counterclockwise

How to attach the accessories (dough hook, paddle or wire whisk):

  1. Turn OFF (speed '0')
  2. Unplug the mixer or disconnect power. how do you attach the accessories assembling tilt-head mixer 1&2
  3. Tilt the motor head back.
    how do you attach the accessories assembling tilt-head mixer 3
  4. Slip accessory onto beater shaft and press upward as far as possible. how do you attach the accessories assembling tilt-head mixer 4
  5. Turn accessory to the right, hooking beater over the pin on the shaft. how do you attach the accessories assembling tilt-head mixer 5

How to remove the accessories (dough hook, paddle or wire whisk):

  1. Turn OFF (speed '0')
  2. Unplug the mixer or disconnect power.
  3. Tilt motor head back.
  4. Press beater upward as far as possible and turn left.
  5. Pull beater from beater shaft.

How to check the bowl clearance (height):

Your mixer is adjusted at the factory for optimum mixing, with the paddle (flat beater) just clearing the bottom of the bowl. If, for any reason, this hits the bottom of the bowl or is too far away from the bowl, you can correct it quickly.

  1. Turn OFF (speed '0')
  2. Unplug the mixer or disconnect power.
  3. Tilt motor head back.
  4. Turn the screw SLIGHTLY counterclockwise (left) to raise the paddle or clockwise (right) to lower the paddle.
  5. Adjust so that the paddle just clears the surface of the bowl. If you over adjust the screw, you may not be able to lock the motor head when it is lowered.

NOTE: When correctly adjusted, the paddle will not strike the bottom or side of the bowl. If the paddle is too low and it strikes the bowl, the coating may wear off the beater, or the wires on the whisk may wear.

Signs that your mixer needs to be adjusted:

  • Ingredients on the bottom of the bowl are not being incorporated means the beater is too high.

  • Head not locking into place means the beater is too high.

  • The white paddle is chipping on the bottom means the beater is too low.

Was this article helpful?

yesno